Raspberry pi Zero W - NOOBS installation? - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3) +--- Thread: Raspberry pi Zero W - NOOBS installation? (/showthread.php?tid=376) |
Raspberry pi Zero W - NOOBS installation? - Nick_Currawong - 2017-03-12 Hi guys, I have just bought a new Rpi0W, and downloaded the latest op version 0.9. When I boot up I get a pop up box message ; "No network access" "Wired network access is required to use NOOBS without local images." I have checked the /os/OpenPlotter dir and it appears to have the required files; boot.tar.xz OpenPlotter.png os.json partition_setup.sh partitions.json root.tar.xz slides_vga Is the issue due to me trying to do it on a Rpi0 and it needing different images/tar files? Any ideas or thoughts? Thanks RE: Raspberry pi Zero W - NOOBS installation? - lone_viper - 2017-03-12 Have you also go the directories not just the root files?? I did the same thing until I realise I was missing the actual openplotter image RE: Raspberry pi Zero W - NOOBS installation? - Nick_Currawong - 2017-03-12 Hi Lone_Viper, Thanks for the quick reply, The images are there *.tar.xz. But the first issue is/was that in the os.json , it has a tag called "supported_models" which only had Rpi 2 & 3 in its list. So as I trying to do it on a Zero didn't match anything on the list, hence no local images found, fallback to a network installation. I have removed the tag and it's installing now. I will post about the outcome. Thanks Hi guys, An update, after that little hack , I got op to install and gui starts and runs, spiking the cpu (as expected). OpenCPN doesn't start, from other forums, it is most likely that it was compiled for arm7's and the Zero is an arm6, so that is why I'm getting an "illegal instruction ". So I will recompile from source and see what happens and probably have to do Signal K as well (from forums). Thanks RE: Raspberry pi Zero W - NOOBS installation? - nadezhda - 2017-04-19 (2017-03-12, 07:27 PM)Nick_Currawong Wrote: Hi Lone_Viper, Nick Can you let me know how you got on with the Pi Zero since I've just installed on mine and had the "illegal instruction" message as well? Thanks - Pete RE: Raspberry pi Zero W - NOOBS installation? - JD1 - 2017-07-08 Any progress/update on installation on a pi zero or pi zero W ? |