MCP6002 Op Amp circuit - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: General discussion (https://forum.openmarine.net/forumdisplay.php?fid=2) +--- Thread: MCP6002 Op Amp circuit (/showthread.php?tid=3800) |
MCP6002 Op Amp circuit - Bryant11 - 2021-12-08 I want to make a project about MCP6002 Op Amp circuit. If I were using Channel 1 on an oscilloscope to measure Vin (supplied by a sinusoidal signal), and Channel 2 on the oscilloscope to measure Vout, do I put the o-scope Channel 1 probe right before the input pin of the OPAMP and the o-scope Channel 2 probe right before the output pin of the OPAMP, respectively? Sorry, stupid question. But I haven't done circuit construction in a while, and I'm trying to refresh my memory. |