I2c Adress with TCA9548A - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: Bug Reports (https://forum.openmarine.net/forumdisplay.php?fid=4) +--- Thread: I2c Adress with TCA9548A (/showthread.php?tid=3876) |
I2c Adress with TCA9548A - croy - 2022-01-17 Please help, i want to use the TCA9548A I2C multiplexer to read 4 BMP280 sensors. But the I2C tool shows me only one I2C adress (0X71) instead of the 8 adresses of the multiplexer. 0 1 2 3 4 5 6 7 8 9 a b c d e f 00: -- -- -- -- -- -- -- -- 10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 30: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 60: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- 70: -- 71 -- -- -- -- -- -- so, where is this to change, that i can define the right adresses in the ic2 tool, soi can use signal-k for the sensors on the multiplexer ? thank for your help sorry for my english, i'm austrian RE: I2c Adress with TCA9548A - Sailoog - 2022-01-18 I have no experience with that module but I think you just need one address to get data from your 4 bmp sensors. That is what a multiplexer does. Anyway, I am not sure that the TCA9548A will work with the current OP I2C app. Connecting the 4 bmp sensors in parallel using different addresses would work. |