+- OpenMarine (https://forum.openmarine.net)
+-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1)
+--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3)
+--- Thread: Help witn NMEA 0183 to Raymarine ST60plus (/showthread.php?tid=3916)
Help witn NMEA 0183 to Raymarine ST60plus - Thoma_s - 2022-02-08
Hi
I have a raspberry 4 with open plotter.
Conected throught two usb converters a signal from
Raymarine ST60plus NMEA 0183 signal in and out.
I have done setup of signlk and open Cpn
Sometimes it gets signals back and fourth but for the most no signal goes to Raymarine.
OpenCpn works fine with Ais and usbGPS
Any tips
RE: Help witn NMEA 0183 to Raymarine ST60plus - SCarns - 2022-02-08
I'm not clear that your routing is correct. In OpenCPN, your UDP should be "Out" and you'll need a port in Signalk to receive any of that data. However, I'm not sure that's needed, unless you are sending back calculated data or autopilot info from OpenCPN. Also, double check to make sure your SK events are dumping data into "seatalkOut" and that is routed properly. Perhaps you can add a screen shot of your "ray" connections.
I'd expect that you'll have the NMEA0183 -> NMEA0183 plugin install and forward the sentences you want to "seatalkOut". Then in your "ray" connections, you'll send those "seatalkOut" events to those ports.
RE: Help witn NMEA 0183 to Raymarine ST60plus - Thoma_s - 2022-02-17
Hi
I will try these suggestion.
I have installed the pluggin yes.
I think the routing is not correct.
Never done this before.
RE: Help witn NMEA 0183 to Raymarine ST60plus - Thoma_s - 2022-03-17
Anyone?
RE: Help witn NMEA 0183 to Raymarine ST60plus - Techstyle - 2022-03-19
(2022-03-17, 05:43 PM)Thoma_s Wrote: Anyone?
forget about your OpenCPN connections for a moment. In Signal K Data Browser - do you see anything that looks like its coming from the ST60? like wind, depth, speed or whatever you have attached?
if it sometimes works does the data make sense? what is the USB device you are using?
RE: Help witn NMEA 0183 to Raymarine ST60plus - e-sailing - 2022-03-25
Are you sure that your st60 work with 38400? I think it should be 4800.
rayut:
Output Events : nmea0183out
Sentence Events : --
rayinn:
Output Events : --
Sentence Events : -- "you can enter here something if you want to send it to special output"
Use the signalk plugin "Forward and filter NMEA0183 input to NMEA0183 out" (Output event = nmea0183out, Input event = GPSout)
In gps set Sentence Events: GPSout
RE: Help witn NMEA 0183 to Raymarine ST60plus - Thoma_s - 2022-04-13
Thanks.
This worked.