OP 3 and Signal K 1.45 CAN bus - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: Bug Reports (https://forum.openmarine.net/forumdisplay.php?fid=4) +--- Thread: OP 3 and Signal K 1.45 CAN bus (/showthread.php?tid=4225) |
OP 3 and Signal K 1.45 CAN bus - GER-387 - 2022-09-12 Hello, my OP 3 on a Raspi 4B 2GB on a MCS board was up and running well together with my seatalk ng network until I updated Signal K to version 1.45. Now Signal K receives no data anymore from the n2k network. Has anybody an idea how I can fix that or How I can get back to Signal K 1.44? Regards Thomas RE: OP 3 and Signal K 1.45 CAN bus - holgerw - 2022-09-12 my n2k hat works as before. check your cables. RE: OP 3 and Signal K 1.45 CAN bus - GER-387 - 2022-09-12 Definitly not a cable issue RE: OP 3 and Signal K 1.45 CAN bus - holgerw - 2022-09-13 my CAN0 init looks so: : dmesg | grep can0 [ 7.582699] mcp251x spi0.0 can0: MCP2515 successfully initialized. [ 8.706944] IPv6: ADDRCONF(NETDEV_CHANGE): can0: link becomes ready RE: OP 3 and Signal K 1.45 CAN bus - GER-387 - 2022-09-15 I reinstalled Signal K 1.44.0 and the CANBUS data was visible again in CPN. There must be something not running well. I gave it also to the Signal K community but they refuse any issue neither. Regards Thomas |