OP3 windtrim Navman/raymarine - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3) +--- Thread: OP3 windtrim Navman/raymarine (/showthread.php?tid=4439) |
OP3 windtrim Navman/raymarine - cepicscepics - 2023-01-25 Hi all, I migrated recently to op3 and my windtrim config doesn't work anymore... here my old solution.. I need to send, to the raymarine st1000+, VWR nmea0183 sentences generated by signalk to nmea0183 plugin.. this is my new signalk setup: I tried two "pilot's usb/serial adapter" and the following connections raymarine st1000+ usb/serial adapter nmea+ --------------------> A nmea- --------------------> B nmea+ --------------------> A GRD --------------------> B ... but the pilot doesn't want to switch to windtrim mode (auto+stanby) some tips? i'm missing something .... but what? rpi3 OP3 hub usb gps usb check sistem log: Checking NTP server... | running Checking Power off management... | disabled Checking Shutdown management... | disabled Checking OpenPlotter autostart... | enabled Checking rescue mode... | disabled Checking debugging mode... | disabled Checking system log file size... | System log file size: 21.83 MB Checking OpenPlotter packages source... | added Checking SDR processes... | SDR AIS is not running Checking Notifications... | running | Access to Signal K server validated Checking GPIO... | pigpiod running | Seatalk1 disabled | 1W enabled | pulses disabled | digital disabled | openplotter-gpio-read not running | Access to Signal K server validated Checking I2C sensors... | openplotter-i2c-read running | I2C enabled | Access to Signal K server validated Checking pypilot... | pypilot_boatimu running | openplotter-pypilot-read running | Access to Signal K server validated | pypilot_web not running | pypilot_hat not running Checking WIFI Access Point password... | changed Checking serial connections alias... | All your serial connections have an assigned alias Checking Dashboards... | Kip enabled Checking OpenCPN... | running | | autostart disabled Checking Signal K server... | running Checking serial connections conflicts... | no conflicts Checking network connections conflicts... | no conflicts Checking GPIO conflicts... | no conflicts CHECK SYSTEM FINISHED RE: OP3 windtrim Navman/raymarine - Sailoog - 2023-01-25 I assume you want to use the /dev/ttyOP_pilotout device to send data. You need to add the event nmea0183out in the field "Output events" of your signal k connection for this device. when you set a serial connection in signal k, it works only as input by default, if you want it to work as output too, you need to tell the Signal k server what events you want to send. Events are like "labels", you can label any data entry (event) and then use that label to identify the data and define outputs. Events explained: https://openplotter.readthedocs.io/en/3.x.x/signalk/multiplexing.html RE: OP3 windtrim Navman/raymarine - cepicscepics - 2023-02-08 (2023-01-25, 02:10 PM)Sailoog Wrote: I assume you want to use the /dev/ttyOP_pilotout device to send data. You need to add the event nmea0183out in the field "Output events" of your signal k connection for this device. I think I have a serial adapter or a connection problem because the problem persist following your tip also..... till searching......... |