Lost Alias - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3) +--- Thread: Lost Alias (/showthread.php?tid=4464) |
Lost Alias - Rae Simpson - 2023-02-09 I added devices via signal K and they seem to work OK. BUT - I'm not getting benefit of aliases and OpenPlotter complains on start up....... Checking serial connections alias... ↳There are serial connections with no alias assigned: Signal K -> connection ID: GPSPuck | device: /dev/serial/by-id/usb-u-blox_AG_-_www.u-blox.com_u-blox_7_- _GPS_GNSS_Receiver-if00 Signal K -> connection ID: VHF | device: /dev/serial/by-id/usb-FTDI_FT232R_USB_UART_AH06ROZO-if00-port0 Serial displays the 2 connections in red but not under devices. Looking for advise on how to correct this. Cheers... Rae Install is on a 64 bit Raspberry Pi 4, with the latest updates. RE: Lost Alias - Sailoog - 2023-02-09 To get rid of those messages, you can set aliases in the openplotter-serial app before setting up the Signal k connections, it does not hurt and gives extra security. Or you can just uninstall openplotter-serial app if you do not use it. RE: Lost Alias - Rae Simpson - 2023-02-15 (2023-02-09, 11:28 AM)Sailoog Wrote: To get rid of those messages, you can set aliases in the openplotter-serial app before setting up the Signal k connections, it does not hurt and gives extra security. Or you can just uninstall openplotter-serial app if you do not use it. Is there a process/procedure for adding serial alias after installing connections via Signal-K? RE: Lost Alias - Sailoog - 2023-02-16 just create the alias in openplotter-serial and go to signal k administrator and replace the current devices by the new alias. RE: Lost Alias - Rae Simpson - 2023-02-16 There is no ability to expose or add the devices in openplotter-serial. At least from the UI. Is there another way? RE: Lost Alias - Sailoog - 2023-02-18 If Signal k detects your serial devices but openplotter-serial does not, that means that somehow you have lost permission to read serial devices for non admin users. To confirm this open a terminal and type: lsusb then type this and compare results: sudo lsusb any difference? RE: Lost Alias - Gandan - 2023-07-29 (2023-02-18, 07:24 PM)Sailoog Wrote: If Signal k detects your serial devices but openplotter-serial does not, that means that somehow you have lost permission to read serial devices for non admin users. Hello! Same problem here: Serial GNSS hat doesn´t show up as device but the connection is there (GPSD) and it works. No alias though and can´t find any way to create one. Activated the connection with the GNSS following instrtuctions on https://www.waveshare.com/wiki/MAX-M8Q_GNSS_HAT: #Open gpsd file sudo nano /etc/default/gpsd #Change the below codes of file and save USBAUTO="false" DEVICES="/dev/ttyS0" GPSD_OPTIONS="/dev/ttyUSB0" |