+- OpenMarine (https://forum.openmarine.net)
+-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1)
+--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3)
+--- Thread: Get rool and pitch in Signal K (/showthread.php?tid=4470)
Get rool and pitch in Signal K - vincenthure - 2023-02-10
My setup is PI 4B with Open-Plotter setting 3.4.7 and Pypilot 3.2.9
I have a IMU 9250/6500 connected on the I2C port
I succefully configure the IMU in Pypilot soft.
Now I would like to read pitch and roll in the dashboard.
But this data did'nt appears in signal K.
Should I create a new connection?
Vincent
dashboard.pdf (Size: 61.41 KB / Downloads: 110)
device.pdf (Size: 45.83 KB / Downloads: 85)
RE: Get rool and pitch in Signal K - Sailoog - 2023-02-12
you need to select "Enable IMU only" in openplotter-pypilot
RE: Get rool and pitch in Signal K - vincenthure - 2023-02-13
Ok thank you, It work for me.
But is it a way to get the data when the pypilot is enable?
RE: Get rool and pitch in Signal K - Sailoog - 2023-02-13
it should also work in "autopilot" mode.