SignalK : not getting everything - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3) +--- Thread: SignalK : not getting everything (/showthread.php?tid=456) |
SignalK : not getting everything - svsputnik1 - 2017-04-11 Hey guys I'm playing a lot with openPlotter these days. I have a BNo055 chip for IMU, an Adafruit Ultimate GPS and the BMP280 for barometric pressure. I'm getting the pressure allright via a dedicated node on node-red but I though I could just tap into the signalK stream and get everything at the same place, instead of rebuilding nodes on the side. I'm connecting to signalK via websocket, but I seem to only be getting course overground data. I was wondering where I can find the whole list of signalK attributes supported by OP 0.8?? Anybody made progress on this? I would like to have a dashboard with the heel of the boat for instance. sam |