OpenCPN Hangs and System Hangs - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: General discussion (https://forum.openmarine.net/forumdisplay.php?fid=2) +--- Thread: OpenCPN Hangs and System Hangs (/showthread.php?tid=4642) |
OpenCPN Hangs and System Hangs - SVHM - 2023-05-18 I installed a complete OpenPlotter update on a Rasberry Pi 3+ and now the system is a mess. OpenCPN almost doesn't work at all. If I go into OpenCPN in regular mode the entire system locks up and requires a hard shutdown. In safe mode it hangs only OpenCPN. The is a process that is called "Node" (PID 430, State R, PPID 423) that is using 30 to 50% of the resources without me opening any programs. Could that have anything to do with it? So far, I have not performed any setup procedures in OpenPlotter, so I don't think I have messed anything up. The only thing I have done is put the maps in a directory and point OpenCPN to them. I would appreciate any help. RE: OpenCPN Hangs and System Hangs - holgerw - 2023-05-18 could be indexing the maps.... ... this will take some time. RE: OpenCPN Hangs and System Hangs - SVHM - 2023-05-18 (2023-05-18, 01:27 PM)holgerw Wrote: could be indexing the maps.... When I pointed to the maps, it indexed already. I was able to see the maps. I don't think that's it. I didn't install a new system, I just did a major update because the system hasn't been used in a year. The installer, however seemed to install OpenCPN new because I had to install all new plugins and point to the maps. RE: OpenCPN Hangs and System Hangs - holgerw - 2023-05-18 Are you using openplotter v3 ? What os is The pi? Better use an Image as Update an Oldie System < 2. RE: OpenCPN Hangs and System Hangs - SVHM - 2023-05-18 (2023-05-18, 02:23 PM)holgerw Wrote: Are you using openplotter v3 ? Version of OpenPlotter is 2.9.1 OS is OpenPlotter. I don't remember ever installing anything different. Do you mean I should wipe disk and install an old OP version? RE: OpenCPN Hangs and System Hangs - holgerw - 2023-05-18 yes - make backup in signal k. look here for backup openplotter 2. better get an new sd card and install openplotter 3. RE: OpenCPN Hangs and System Hangs - SVHM - 2023-05-19 (2023-05-18, 08:39 PM)holgerw Wrote: yes - make backup in signal k. OK, I reinstalled and it seems to be working now. Thanks RE: OpenCPN Hangs and System Hangs - holgerw - 2023-05-19 (2023-05-19, 04:46 AM)SVHM Wrote:(2023-05-18, 08:39 PM)holgerw Wrote: yes - make backup in signal k. Fine keep on sailing. Holger RE: OpenCPN Hangs and System Hangs - SVHM - 2023-05-21 Now that I have the new version 3 installed, I need to install Pypilot. Under the settings tab Pypilot has a reasberry icon next to it and the line is grayed out. When I select Install, it doesn't do anything. It seems disabled. I am following the Workbook. Have the steps changed with v3? |