HDMI2 fuzzy - on CM4 board - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: OpenPlotter (https://forum.openmarine.net/forumdisplay.php?fid=1) +--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=3) +--- Thread: HDMI2 fuzzy - on CM4 board (/showthread.php?tid=4946) |
HDMI2 fuzzy - on CM4 board - Caper - 2023-10-15 Hello everyone - new to this forum and new to openplotter on pi. I have a cm4 module on a waveshare minibase A board and I am trying to run both HDMI screens - 1 for a cockpit monitor and 1 at the chart table. I cannot get the second HDMI - the one with a FFC connector) to work properly. The best I have got is a hazy flickering output on HDMI 2. It will only come up when I replug the hdmi cable, not on boot. I am wondering if this is a hardware problem with the CM4 board. I have changed the waveshare baseboard and it made no difference. I have tested the cables and monitors and it all works fine using a different computer. Does anyone have any idea where I start to troubleshoot this? Thank you. |