![]() |
Motordriver high corrent - Printable Version +- OpenMarine (https://forum.openmarine.net) +-- Forum: Pypilot (https://forum.openmarine.net/forumdisplay.php?fid=17) +--- Forum: For sale (https://forum.openmarine.net/forumdisplay.php?fid=25) +--- Thread: Motordriver high corrent (/showthread.php?tid=5065) |
Motordriver high corrent - frir - 2023-12-26 My Situation: I have to drive a brushed motor reversible hydraulic pump (Simrad rpu300- 24 V) with max power consumption of 12 A. Is there any way to drive this pump with pypilot what motor driver could i use and what motor.ino would work with this driver. I would be very glad if somebody could give me a hint how to go on. Best regards fritz RE: Motordriver high corrent - Kennyboy - 2023-12-28 I had the same problem and I've adapted the arduino slightly to drive a Deventech MD03 that I already had, the D6 pin on the arduino needs to be pulled to +v to do this. Only thing is you've posted this in the 'for sale'....but you're doing better than me because I can't seem to start a new thread at all!! RE: Motordriver high corrent - frir - 2023-12-29 (2023-12-28, 06:48 PM)Kennyboy Wrote: I had the same problem and I've adapted the arduino slightly to drive a Deventech MD03 that I already had, the D6 pin on the arduino needs to be pulled to +v to do this. Thank you for your replay. If I understand you good I have just to pull up D6 (over maybe a 10 K resistor) to v+? That´s th RC-PWM mode. I noticed it that my Thread is in the wrong directory but I´m unable to undo it. For opening a Thread: Go to pipilot -Genal Discussion. On top and button right ther is the button fo New Thread. Than go down completly and yo will see: Post Thread. |