+- OpenMarine (https://forum.openmarine.net)
+-- Forum: MacArthur HAT (https://forum.openmarine.net/forumdisplay.php?fid=29)
+--- Forum: How do I...? (https://forum.openmarine.net/forumdisplay.php?fid=31)
+--- Thread: Problems installing NMEA 2000 | you can not select GPIO (/showthread.php?tid=6111)
Problems installing NMEA 2000 | you can not select GPIO - aguglielmi - 2025-03-21
Hello everybody
I'm trying to setup a new instal PI5 +NVVME + MacHartur HAT
When I try to install CAN COnnection adding a new MCP251xdf device I'm not able to select the power GPIO 25, I always get the message "you can not select GPIO to do this job.
Anu Idea will be appreciated
Regards
RE: Problems installing NMEA 2000 | you can not select GPIO - Sailoog - 2025-03-21
You are probably confusing GPIO 25 with pin 25. Use the columns BCM of this table: https://macarthur-hat-documentation.readthedocs.io/en/latest/pinout.html
RE: Problems installing NMEA 2000 | you can not select GPIO - aguglielmi - 2025-03-22
(2025-03-21, 07:29 PM)Sailoog Wrote: You are probably confusing GPIO 25 with pin 25. Use the columns BCM of this table: https://macarthur-hat-documentation.readthedocs.io/en/latest/pinout.html
Hello
Thanks a lot!