hi
I've made a direct connection between a ublox gps unt and the raspberry pi serial GPIO input
for background information see
http://www.instructables.com/id/Read-and...pberry-Pi/
for safety i've connected the u blox to a 3.3 V GPIO pin
On a Pi3 the serial is ttyS0 and after disabling the console output to s0 it more or less works
Open Plotter occasionaly drops the connection which can be corrected with an action like "restart nmea restart kplex after 5 sec no new data on GPS time signal)
Hi
it seems i've been to quick to cheer
My direct serial connection between a gps and the raspberry pi works, but is unstable
If I check the input with the cutecom terminal program something else is also writing data to the serial input
any suggestions how to disable this signal ?
Nb i have checked the command.txt file the serial console is disabled
I've made a direct connection between a ublox gps unt and the raspberry pi serial GPIO input
for background information see
http://www.instructables.com/id/Read-and...pberry-Pi/
for safety i've connected the u blox to a 3.3 V GPIO pin
On a Pi3 the serial is ttyS0 and after disabling the console output to s0 it more or less works
Open Plotter occasionaly drops the connection which can be corrected with an action like "restart nmea restart kplex after 5 sec no new data on GPS time signal)
Hi
it seems i've been to quick to cheer
My direct serial connection between a gps and the raspberry pi works, but is unstable
If I check the input with the cutecom terminal program something else is also writing data to the serial input
any suggestions how to disable this signal ?
Nb i have checked the command.txt file the serial console is disabled