Hello all,
my configuration is Openplotter 3 newly installed and updated on Raspberry 3B with OpenCPN 5.6.2,
USB GPS G-Star IV & Sean's anemometer configured on serial to signal K.
Tinypilot running as client of Openplotter, data sent to OpenCPN by Signal K webwebsocket.
Serial K connection on OpenCPN.
Openplotter Network configured as AP, no nft security, no added ethernet port, no sharing internet.
I got quickly data from GPS & anemometer in OPC when starting the Raspi but after some time one or both of these device miss to send data.
It occurs quite surely when launching the browser.
I get back quickly the data by un-plugging then re-plugging USB plug.
Stopping and restarting of OpenCPN don't change the situation.
The major problem is a risk to loose data during operation of tinypilot on GPS mode or Wind mode...
Many thanks if you are able to give me some help.
my configuration is Openplotter 3 newly installed and updated on Raspberry 3B with OpenCPN 5.6.2,
USB GPS G-Star IV & Sean's anemometer configured on serial to signal K.
Tinypilot running as client of Openplotter, data sent to OpenCPN by Signal K webwebsocket.
Serial K connection on OpenCPN.
Openplotter Network configured as AP, no nft security, no added ethernet port, no sharing internet.
I got quickly data from GPS & anemometer in OPC when starting the Raspi but after some time one or both of these device miss to send data.
It occurs quite surely when launching the browser.
I get back quickly the data by un-plugging then re-plugging USB plug.
Stopping and restarting of OpenCPN don't change the situation.
The major problem is a risk to loose data during operation of tinypilot on GPS mode or Wind mode...
Many thanks if you are able to give me some help.