This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › General discussion v
OP/OPENCPN Display "overlap"

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
OP/OPENCPN Display "overlap"
jslpe Offline
Junior Member
**
Posts: 4
Threads: 2
Joined: Jun 2024
Reputation: 0
#1
2024-06-05, 03:55 PM
I can't seem to change my OP display so I have only one plotter screen.  OP/OCPN 5.2.0 running on RPI4.
Display is consistent on startup but I'd prefer one screen rather than two screens that overlap.  Appreciate some help.
Find
Reply
jslpe Offline
Junior Member
**
Posts: 4
Threads: 2
Joined: Jun 2024
Reputation: 0
#2
2024-06-08, 02:19 PM
I figured it out. Somehow my OP sd card came with the dual display setup checked.  I was able to go to preferences and unselect this under general display options.  All good now.
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)