2018-01-08, 01:53 AM
I updated to 0.17.0 today, but couldn't get the MPU-6050 working. In the past it has been recognized as MPU-9150.
After switching sensors, I finally realized that the Pi doesn't recognize the MPU-6050 if the BME280 and HTU21D are installed. i2cdetect -y 1 only shows the the HTU21d at address 40, and the BME280 at address 76.
If I reboot and remove the BME280, the MPU-6050 is recognized at address 68 and works fine.
Anybody else run into that? It seems there was a similar problem in the past.. any ideas?
Many thanks.
Hank
After switching sensors, I finally realized that the Pi doesn't recognize the MPU-6050 if the BME280 and HTU21D are installed. i2cdetect -y 1 only shows the the HTU21d at address 40, and the BME280 at address 76.
If I reboot and remove the BME280, the MPU-6050 is recognized at address 68 and works fine.
Anybody else run into that? It seems there was a similar problem in the past.. any ideas?
Many thanks.
Hank