2023-04-12, 07:51 PM
Hello,
Looking to install a Pypilot to drive a linear actuator (installed) via relays (installed) for a 9.9hp kicker motor. The existing setup uses a manual port/starboard switch.
I am having troubles navigating the site to basic setup information such as a block diagram, parts required/suggested etc. Is there a starting page to this somewhere?
I suspect this will not be too hard given source code is shared. I just need a push in the right direction.
Thanks in advance for your time.
Cheers,
Steve
Looking to install a Pypilot to drive a linear actuator (installed) via relays (installed) for a 9.9hp kicker motor. The existing setup uses a manual port/starboard switch.
I am having troubles navigating the site to basic setup information such as a block diagram, parts required/suggested etc. Is there a starting page to this somewhere?
I suspect this will not be too hard given source code is shared. I just need a push in the right direction.
Thanks in advance for your time.
Cheers,
Steve