This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › General discussion v
OP on RPI4 - Display question

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
OP on RPI4 - Display question
jslpe Offline
Junior Member
**
Posts: 4
Threads: 2
Joined: Jun 2024
Reputation: 0
#1
2024-06-05, 03:29 PM
NOOB question - I have OP/Opencpn 5.2.0 running on an RPI 4 but the display comes up with two plot screens that overlap. I can reduce one to the right but would like to just use one screen most of the time. Have searched via google and this forum and explored preferences but can't figure out how to just have one plotter screen...I'm sure this is a knowledge limitation on my part.
Find
Reply
jslpe Offline
Junior Member
**
Posts: 4
Threads: 2
Joined: Jun 2024
Reputation: 0
#2
2024-06-08, 08:36 PM
Just to close this out - my SD card came loaded and configured for dual display - which I was able to change going to settings/display/general then change canvas layout from dual to single. seems obvious now....
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)