2024-07-04, 02:08 PM
A bit of history. I have an old AH800 which I have just replaced with a simrad tp10.
The AH 800 was dying but the motor still works fine. I had the idea of replacing the electronics with
a pi zero 2 w and a motor controller- driver board. I have just ordered them from amazon.
Just realised I don't have a clue how to connect them up so that I could control it.
I have a rpi4 with a daisy hat supplying AIS and a GPS receiver. I use signalk to send
to my android tablet running Navionics app.
Anybody got any ideas.
I would assume I should use pypilot but should it be running on the pi zero or on the signalk server.
help
Mick
The AH 800 was dying but the motor still works fine. I had the idea of replacing the electronics with
a pi zero 2 w and a motor controller- driver board. I have just ordered them from amazon.
Just realised I don't have a clue how to connect them up so that I could control it.
I have a rpi4 with a daisy hat supplying AIS and a GPS receiver. I use signalk to send
to my android tablet running Navionics app.
Anybody got any ideas.
I would assume I should use pypilot but should it be running on the pi zero or on the signalk server.
help
Mick