accesspoint issue OP4

[wimsl]

just installed OP v4 and now I see accesspoint is rather different. no network config any longer in OPsettings.  so big question is no where to find what can be adapted?
next question is that it uses 10.42.0.1 instead of the old -and good working- 10.10.10.1
3rd question is -even after password update- I still can not connect from oher devices
last, also from localhost I can not connect signal-K

what could I have done wrong?

I feel I need to make settings in signal K but I cannot connect.

when I do netstat -pan --inet I do not see localhost with port 3000 in  use

networkinfo from setting:
VNC remote dekstop (server)
TCP rpi4b.local:5900
TCP 192.168.100.38:5900
TCP 192.168.100.39:5900
TCP 10.42.0.1:5900
Avnav web interface (server)
TCP rpi4b.local:8080
TCP 192.168.100.38:8080
TCP 192.168.100.39:8080
TCP 10.42.0.1:8080
osOENC chart plugin (server)
TCP rpi4b.local:8082
TCP 192.168.100.38:8082
TCP 192.168.100.39:8082
TCP 10.42.0.1:8082
Avnav updater (server)
TCP rpi4b.local:8085
TCP 192.168.100.38:8085
TCP 192.168.100.39:8085
TCP 10.42.0.1:8085
Avnav to Signal K (server)
TCP rpi4b.local:28628
TCP 192.168.100.38:28628
TCP 192.168.100.39:28628
TCP 10.42.0.1:28628
Signaal K - Admin (server)
TCP rpi4b.local:3000
TCP 192.168.100.38:3000
TCP 192.168.100.39:3000
TCP 10.42.0.1:3000
Signal K - NMEA 0183 uitvoer (server)
TCP rpi4b.local:10110
TCP 192.168.100.38:10110
TCP 192.168.100.39:10110
TCP 10.42.0.1:10110

[wimsl]

after sme checking and testing I found out why. if you install OP using another user than PI it dont work because all signal will be set uo for user pi so you need to log in as PI before doing all abiove.

moderator, pls close?