2024-04-02, 11:56 AM
I want to install a switch that will allow me to power up regardless of whether the N2K network is connected. I want this while testing when the N2K network isn't needed.
ON 1 - Would power up with 12VDC to the switch connector on the MacArthur directly from the primary 12VDC source.
OFF - No power; RPI5 would not power up
ON 2 - Would power up with 12VDC to the switch connector on the MacArthur from the N2K drop.
I don't see a reason or problems with this setup.
Pax,
Mo
ON 1 - Would power up with 12VDC to the switch connector on the MacArthur directly from the primary 12VDC source.
OFF - No power; RPI5 would not power up
ON 2 - Would power up with 12VDC to the switch connector on the MacArthur from the N2K drop.
I don't see a reason or problems with this setup.
Pax,
Mo