2024-07-27, 07:25 AM
I'm new to OpenMarine and have just installed it on to a rpi this week. Both NMEA0183 and NMEA2000 data stops after running for a few hours. Upon starting the Rpi, the SignalK's dashboard shows both NMEA0183 and NMEA2000 connections with activity. But later, both do not show any activity. Restarting SignalK does nothing. Only after rebooting the Rpi will data activity start again.
I have openCPN running on the Rpi and a laptop. The OpenCPN connection on the Rpi is protocol=SignalK, address=localhost, and port=3000. On the laptop the connection is protocol=UDP, address=127.0.0.1, and port=10109. The laptop IP address is 192.168.57.8. The settings in signalK's UDP NMEA0183 Sender are broadcast address=192.168.57.255, port=10109, and use server event nmea0183 & nmea0183out are both enabled.
Any help on what I'm doing wrong would be appreciated.
I have openCPN running on the Rpi and a laptop. The OpenCPN connection on the Rpi is protocol=SignalK, address=localhost, and port=3000. On the laptop the connection is protocol=UDP, address=127.0.0.1, and port=10109. The laptop IP address is 192.168.57.8. The settings in signalK's UDP NMEA0183 Sender are broadcast address=192.168.57.255, port=10109, and use server event nmea0183 & nmea0183out are both enabled.
Any help on what I'm doing wrong would be appreciated.