2020-06-14, 04:30 PM
Hi all.
I'm new to this forum and I have a problem I can't figure out.
I have a setup with an RPI 4 4G, StromPi V3 HAT, Strompi BatteryHAT and MoitessierHAT 2.
When I use the Openplotter image on the SD-card and try to run the script and GUI for the StromPi HAT, nothing works. Settings don't change, GUI doesn't start.
I've tried to take te Raspian Buster image that you can download from the strompi website, which has everything pre-installed neccesary for the strompi and I've installed OpenPlotter on top of that following the 'Advanced' manual on the Sailoog website.
This works fine, until I install the MoitessierHAT package. When I try to reboot after installing the MoitessierHAT package, the Pi doesn't boot anymore.
Does anyone have experience with this setup?
Sebastiaan
I'm new to this forum and I have a problem I can't figure out.
I have a setup with an RPI 4 4G, StromPi V3 HAT, Strompi BatteryHAT and MoitessierHAT 2.
When I use the Openplotter image on the SD-card and try to run the script and GUI for the StromPi HAT, nothing works. Settings don't change, GUI doesn't start.
I've tried to take te Raspian Buster image that you can download from the strompi website, which has everything pre-installed neccesary for the strompi and I've installed OpenPlotter on top of that following the 'Advanced' manual on the Sailoog website.
This works fine, until I install the MoitessierHAT package. When I try to reboot after installing the MoitessierHAT package, the Pi doesn't boot anymore.
Does anyone have experience with this setup?
Sebastiaan