2020-09-26, 05:27 PM
Hi,
I can’t really make this work...
Have mounted an ssd-sata disc in an usb enclosure. Loaded OP2 on a sdcard and run all updates, both for OP and for the RPI. Then I put the sd card in a card reader and booted the pi on another chip. The op card was copied to the ssd using dd. Finally I set the pi to boot from usb using the method in the link above. So far all is ok.
When I remove the sd card and try to boot from the usb connected ssd disk the system starts up, shows the “rainbow screen”, then the “restore screen” and then...nothing.
I have also set the system to wait for the ssd to become ready.
The only thing I can think of is that under voltage is the cause. This test is made at home with my spare pi, fed by an iPad power supply, I think 2,5v. Aboard I have separate psu‘s for the pi and the usb hub.
Anyone that have other suggestions?
Cheers
P
I can’t really make this work...
Have mounted an ssd-sata disc in an usb enclosure. Loaded OP2 on a sdcard and run all updates, both for OP and for the RPI. Then I put the sd card in a card reader and booted the pi on another chip. The op card was copied to the ssd using dd. Finally I set the pi to boot from usb using the method in the link above. So far all is ok.
When I remove the sd card and try to boot from the usb connected ssd disk the system starts up, shows the “rainbow screen”, then the “restore screen” and then...nothing.
I have also set the system to wait for the ssd to become ready.
The only thing I can think of is that under voltage is the cause. This test is made at home with my spare pi, fed by an iPad power supply, I think 2,5v. Aboard I have separate psu‘s for the pi and the usb hub.
Anyone that have other suggestions?
Cheers
P