2021-04-01, 06:02 PM
Hello,
I have OpenPlotter working on a RP 3B and also pypilot is functioning. I am reprogramming the arduino nano to work with my Neco Autopilot (it should work with the relay box). The Arduino Nano was functioning for a while like I programmed it (for several days) with LED's as motor outputs. After a while it stopped functioning. I tried another nano and it worked for a while but then it stopped again. The same result with an UNO.
On the nano and the UNO I see there is data coming in but then it restarts the board without processing the data?? There is enough power (I used an external power supply on the UNO) and the Arduino only has to power some LEDs..
The communication is sent over the USB ports.
I have tried a clean installation of OpenPlotter and reprogramming the Arduino boards. The result is the same.
If someone has a tip how to solve this I would be grateful.
Rein
I have OpenPlotter working on a RP 3B and also pypilot is functioning. I am reprogramming the arduino nano to work with my Neco Autopilot (it should work with the relay box). The Arduino Nano was functioning for a while like I programmed it (for several days) with LED's as motor outputs. After a while it stopped functioning. I tried another nano and it worked for a while but then it stopped again. The same result with an UNO.
On the nano and the UNO I see there is data coming in but then it restarts the board without processing the data?? There is enough power (I used an external power supply on the UNO) and the Arduino only has to power some LEDs..
The communication is sent over the USB ports.
I have tried a clean installation of OpenPlotter and reprogramming the Arduino boards. The result is the same.
If someone has a tip how to solve this I would be grateful.
Rein