Posts: 5
Threads: 1
Joined: Apr 2017
Reputation:
0
2017-05-06, 04:06 PM
(This post was last modified: 2017-05-22, 06:16 PM by Sailoog.)
Hi guys
I have a RPI3 with hdmi monitor and physical keyboard/mouse.
I downloaded OP 0.10 and after a short positive test I updated to 0.11.3
After restart the keyboard and the mouse do not work.
I can only do a reboot (turning off)
In the recovery mode keyboard and mouse work and I can go back to v0.10
Trying to update OP again shows the problem again
ideas?
Posts: 3,038
Threads: 63
Joined: Mar 2016
Reputation:
289
Could you try using a fresh raspbian installation?
Posts: 6
Threads: 0
Joined: Apr 2017
Reputation:
0
I have nearly the same problem. Is it correct to use this treath or schould a make a new one?
Here is the problem:
I have a 12"-Monitor with an eGalax touchscreen connected to USB, this works with 0.9. After Updating Openplotter the touchscreen didn't work.
I connected a mouse, which was ok. The i tested 0.9 agein, the touch works. I changed the RPI 3 with an RPI 2, same behaviour. Then i took the SD-Card in an RPI with original 7"-Touch. This combination is working with the 0.9 an the newer Version of openplotter.
lsusb on the console shows me, that the touchscreen is recognized.
Dirk
Posts: 5
Threads: 1
Joined: Apr 2017
Reputation:
0
2017-05-12, 09:05 PM
(This post was last modified: 2017-05-12, 09:10 PM by ellgia.)
Hi
I did not install a 'fresh Raspibian'.
I reinstalled OP 0.10 and retried the update to 0.11.4. Following the upgrade process carefully I saw an i / o error and a read only error reported, then the process abort and rpi3 reboot without upgrading.
In this abnormal condition the system freezes.
I tried to replace the LEXAR 16Gb U1 SD card with a SAMSUNG 32Gb EVO U1 and it all worked fine.
With the new SD the update has been successful at 0.11.4.
I tested the I2C MPU9150 HTU21 and BMP180 sensors without any problems.
In inspector I see the K signal I have configured.
Tonight I try to generate NMEA.
See you soon