2024-09-01, 08:13 AM
Hi, I am running Openplotter 4 on a RPi 5 with a MacArthur hat.
I have added the following I2C devices and configured the values to go into signal K with no problem:
- AHT30
- BMP388
- ICM
However, after adding an ADS1115 sensor, when I go to edit a value to pass to signal K, once I click OK, all the sensors in the I2C app disappear. Although I can see the data is still being sent to Signal K, I just can no longer see or edit any of the sensors. Adding them back in brings them up, as long as I dont try to add the ADS1115.
Tried rebooting, still shows an empty list of sensors.
I am running I2C 4.2.0.
I've tried turning on debugging and opening through terminal, but not getting any debugging prints from I2C app.
Going to configure A0:
And after pressing OK:
Is this a bug, or am I doing something stupid?! The latter is most certainly a possibility!
I have added the following I2C devices and configured the values to go into signal K with no problem:
- AHT30
- BMP388
- ICM
However, after adding an ADS1115 sensor, when I go to edit a value to pass to signal K, once I click OK, all the sensors in the I2C app disappear. Although I can see the data is still being sent to Signal K, I just can no longer see or edit any of the sensors. Adding them back in brings them up, as long as I dont try to add the ADS1115.
Tried rebooting, still shows an empty list of sensors.
I am running I2C 4.2.0.
I've tried turning on debugging and opening through terminal, but not getting any debugging prints from I2C app.
Going to configure A0:
And after pressing OK:
Is this a bug, or am I doing something stupid?! The latter is most certainly a possibility!