2018-06-03, 11:00 AM
(This post was last modified: 2018-06-04, 10:30 AM by waldmattis.)
Good morning.
This morning I downloaded Noobs for Openplotters.
I formatted a sd-card with SD-Formatter and unzipped the
file to the freshly formatted sd-card.
I put the card into my Raspberry Pi 2 rev. B and switched Power on.
Immidiately the Green LED lighted without a break.
After 30 minutes I shut down.
Is this hanging on boot a known problem?
Is there any help?
Regards
Karl
This morning I downloaded Noobs for Openplotters.
I formatted a sd-card with SD-Formatter and unzipped the
file to the freshly formatted sd-card.
I put the card into my Raspberry Pi 2 rev. B and switched Power on.
Immidiately the Green LED lighted without a break.
After 30 minutes I shut down.
Is this hanging on boot a known problem?
Is there any help?
Regards
Karl