My connections are good. The SPI interface is enabled. I boot from a 0.17 SD card and it works. Put in v1 and it does not with same settings. I see it in signal k but 0 volts. With or without conversion through table.
Also, the word "aktiv" in this module shows in English translation, I assume this should say "active". It has been that way forever.
Sent from my Moto G (5) Plus using Tapatalk
Also, the word "aktiv" in this module shows in English translation, I assume this should say "active". It has been that way forever.
Sent from my Moto G (5) Plus using Tapatalk