2019-02-14, 06:08 AM
I was thinking of using a view ESP32 (DOIT ES32 DEVKIT V1) to mount remotely from the Raspi (engine room – for engine monitoring, close to water and fuel tank -liquid level sensor, mast head – wind sensor…).
I like to use the Bluetooth Low Energy to request and send the sensor readings to the Rasp PI (open cpn) with a ACROBOTIC Bluetooth 4.0 Low Energy USB Module (BLE Computer Adapter).
- low energy, rechargeable battery, could last over one year
- request sensor info on a user definable time interval (1 min, 5 min, 15 min, hourly....)
- display sensor readings on smart phone, Pi display, …
- User can build remote sensors based on Arduino IoT
I’m not a programmer but I like to get some feedback. Any advice?
I like to use the Bluetooth Low Energy to request and send the sensor readings to the Rasp PI (open cpn) with a ACROBOTIC Bluetooth 4.0 Low Energy USB Module (BLE Computer Adapter).
- low energy, rechargeable battery, could last over one year
- request sensor info on a user definable time interval (1 min, 5 min, 15 min, hourly....)
- display sensor readings on smart phone, Pi display, …
- User can build remote sensors based on Arduino IoT
I’m not a programmer but I like to get some feedback. Any advice?