Posts: 2,784
Threads: 59
Joined: Mar 2016
Reputation:
256
2021-01-17, 09:48 PM
(This post was last modified: 2021-01-17, 09:52 PM by Sailoog.)
You have to set your 1W sensors only in the 1W tab and enable read/write permission in Signal k server when required.
Unless you are conecting a seatalk 1 device, remove and disable anythink in seatal 1 tab.
Posts: 2,784
Threads: 59
Joined: Mar 2016
Reputation:
256
The ws connection is for any device using the GPIO app (1W, digital, pulse) and it should be aproved just once. Seatalk1 has its own connection.
To aprove the ws access go to "signal k - security - Access requests". Once approved this access should appear in "signal k - security - Devices".
Read the messages you will get in the openplotter-gpio app and you will be guided.
Posts: 2,784
Threads: 59
Joined: Mar 2016
Reputation:
256
what happens if you press "refresh"?
Posts: 2,784
Threads: 59
Joined: Mar 2016
Reputation:
256
Click on your device and set read/write instead of just read