Hi,
thank you very much for this project.
I have Raspberry 4 Model B 4GB with OpenPlotter and pypilot installed.
I have bought a motor controller from the pypilot store
https://pypilot.org/store/index.php?rt=p...uct_id=124
(2021 model)
I’ve been reading the workbook
https://github.com/pypilot/workbook/wiki
I follow this part:
https://github.com/pypilot/workbook/wiki...Controller
I have connected the motor controller (4 pin) to the GPIO.
I gave 12 v to the motor controller and a red light show up.
There is also a yellow light when I started openplotter.
I'm at home so there is not a rudder connected to the motor controller.
I can’t “Engaged” Arduino on the autopilot window.
I’m not a tech person and I try my best to find a solution, but I have no idea “where” to look at.
I have some experience with linux command line.
Can somebody provide me any advice?
Please tell me if you need some more information.
Thank you very much
Franco
thank you very much for this project.
I have Raspberry 4 Model B 4GB with OpenPlotter and pypilot installed.
I have bought a motor controller from the pypilot store
https://pypilot.org/store/index.php?rt=p...uct_id=124
(2021 model)
I’ve been reading the workbook
https://github.com/pypilot/workbook/wiki
I follow this part:
https://github.com/pypilot/workbook/wiki...Controller
I have connected the motor controller (4 pin) to the GPIO.
I gave 12 v to the motor controller and a red light show up.
There is also a yellow light when I started openplotter.
I'm at home so there is not a rudder connected to the motor controller.
I can’t “Engaged” Arduino on the autopilot window.
I’m not a tech person and I try my best to find a solution, but I have no idea “where” to look at.
I have some experience with linux command line.
Can somebody provide me any advice?
Please tell me if you need some more information.
Thank you very much
Franco