This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Dual control
#1
Hi all,

I'm new to OP and my learning curve is steep! After installing OP on my RPI4 I was able to control OP from two different units (tablet + lapstop) through WiFi Access Point. Last week I made a change (for testing purposes only) disabling my laptop from being able to make any changes to OP (view only). Now I would like to enable the OP control from my laptop again but I can't remember where I disabled it!!!! Can anyone please give me a lead?

/ Tom
Reply
#2
Replying to my own post!

After a long time of search I finally found it.

1. Right click on the VNC Viewer frame (from laptop logged in to OP)
2. Choose Properties...
3. Under Options, uncheck "View-only"
4. Done!

/Tom
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)