Posts: 2,845
Threads: 59
Joined: Mar 2016
Reputation:
267
The connection is made even if you add a wrong address, click on "I2C addresses" to see the detected addresses.
Posts: 2,845
Threads: 59
Joined: Mar 2016
Reputation:
267
You have also "1a" and "68". what is that?
I remember reading somewhere on this forum about faulty BME280 boards. I should have one somewhere, I'll try it as soon as possible.
Posts: 2,845
Threads: 59
Joined: Mar 2016
Reputation:
267
I have just tested my BME280 and is working right. Not sure what to do now. Could you test your sensor in OpenPlotter 2 to confirm still works?
Posts: 1
Threads: 0
Joined: Feb 2023
Reputation:
0
Hi all,
great work with OpenPlotter!
I have the version 3 (64bit) on an Raspberry Pi 4 8GB with Raspian 64bit.
I have connected via I2C a Bmp280 Sensor via the adress 0x76.
When I start (boot up) the system, no temperature or pressure signals are transmitted.
Only when I log in dirctly to the screen on Raspian, the system check runs, and from the part where the OpenPlotter packages are checked it transmit all the data colected via I2C.
What can I do here?
Thanks for a good solution!
Mitch
Posts: 27
Threads: 3
Joined: Apr 2022
Reputation:
4
It seems to me that I2C Sensors (3.3.12) on OpenPlotter (3.5.0) may be broken.
Running i2cdetect -y 1 from the command line has my BME280 showing up at address 77. However, when trying to run this from OpenPlotter, nothing appears.