2020-01-18, 10:04 PM
Dear PaddyB,
Good evening, hope all is well.
We have been in contact on the forum about EasyESP and the connection to SignalK
I'm still not there ...
Step 1. I was able to connect a 1W sensor via my arduino and configure it like in screenshot 1 (where I send it via WIFI to the SignalK server via UDP to port 55557 (via https://sites.google.com/site/olewsaa/ya...monitoring)
Step2. Via Serial Monitor I can see the sensor works and I get data and temperature
(I have installed Node Red via SignalK app store)
Step 3. Next I add an SignalK Subscribe node
Step 4 Now the difficult part ... Which path do I use ? See the last screenshot. I think I go wrong here, because I do not see anything in the debug window.
Hope you can help.
Bart
Good evening, hope all is well.
We have been in contact on the forum about EasyESP and the connection to SignalK
I'm still not there ...
Step 1. I was able to connect a 1W sensor via my arduino and configure it like in screenshot 1 (where I send it via WIFI to the SignalK server via UDP to port 55557 (via https://sites.google.com/site/olewsaa/ya...monitoring)
Step2. Via Serial Monitor I can see the sensor works and I get data and temperature
(I have installed Node Red via SignalK app store)
Step 3. Next I add an SignalK Subscribe node
Step 4 Now the difficult part ... Which path do I use ? See the last screenshot. I think I go wrong here, because I do not see anything in the debug window.
Hope you can help.
Bart