2020-05-13, 09:51 PM
I've read this post many times and I can't get the Only Compas mode to work.
I followed the steps at the end, listed below. The correct connection seems to be created in SignalK and OpenPlotter on port 20220. I have a MPU9255 connected to my RPi and I can seeĀ in the Data Browser in SK that the navigation attitude roll and pitch are correct but Yaw = null (exactly as on the post above) and headingMagnetic is correct as well.
When in the PyPilot plugin I select Only Compas the Control and Browser Control are "greyed out" and can not be selected. In the Autopilot option - these items can be selected.
Been trying everything I can think of all night but I can't figure it out. Any thoughts anyone?
---- Steps Followed:
- Remove all your connections in Signal k
- In pypilot app select "only compas" (select "autopilot" only if you have connected a pypilot controller)
- In pypilot app go to connections tab, select the data item and click on Add Connection.
- If you want NMEA 0183 data in opencpn use the SK plugin to convert and be sure an input for TCP localhost 10110 exist in opencpn conections.
- If you want to add a GPS or any serial device use the serial app the same way.
I followed the steps at the end, listed below. The correct connection seems to be created in SignalK and OpenPlotter on port 20220. I have a MPU9255 connected to my RPi and I can seeĀ in the Data Browser in SK that the navigation attitude roll and pitch are correct but Yaw = null (exactly as on the post above) and headingMagnetic is correct as well.
When in the PyPilot plugin I select Only Compas the Control and Browser Control are "greyed out" and can not be selected. In the Autopilot option - these items can be selected.
Been trying everything I can think of all night but I can't figure it out. Any thoughts anyone?
---- Steps Followed:
- Remove all your connections in Signal k
- In pypilot app select "only compas" (select "autopilot" only if you have connected a pypilot controller)
- In pypilot app go to connections tab, select the data item and click on Add Connection.
- If you want NMEA 0183 data in opencpn use the SK plugin to convert and be sure an input for TCP localhost 10110 exist in opencpn conections.
- If you want to add a GPS or any serial device use the serial app the same way.