2020-07-06, 10:35 PM
(2020-07-06, 01:37 PM)tkurki Wrote: Enter OPENCPNOUT into Output Events field of APREPEAT connection.
Your connection named OPENCPNOUT is emitting the incoming nmea0183 data as events named OPENCPNOUT. That is a bit confusing, as that data is coming FROM OpenCpn, not being output to OpenCpn. But then again it is output that is generated by OpenCpn....you could name it nmeaFromOpenCpn to be more clear.
So any connection that wants to output the data in events named OPENCPNOUT needs to have that event defined as Output Event.
When I said ”event” in my previous message I was referring to these event names. I believe this is the only meaning where that word is used in the user interface.
Sent from my iPhone using Tapatalk
My connection OPENCPNOUT is not emitting anything as far as I am aware. It is receiving the output data from OpenCPN. I am then trying to use that datastream in nmea0183 to nmea0183 app (as per documentation) to filter and output the stream to my APREPEAT connection which is configured to output APREPEAT 'events' and as far as the documentation is concerned is configured correctly. nema0183 to nmea0183 app Input event OPENCPNOUT and output event APREPEAT.
My naming convention works for me and is perfectly logical.
In English. Take the output from OpenCPN (OPENCPNOUT) and send it to the AP and Repeater (APREPEAT).
This configuration should work but does not. No output is received by the physical devices connected to the APREPEAT serial port.
Cheers
Spart