Hi
I did not install a 'fresh Raspibian'.
I reinstalled OP 0.10 and retried the update to 0.11.4. Following the upgrade process carefully I saw an i / o error and a read only error reported, then the process abort and rpi3 reboot without upgrading.
In this abnormal condition the system freezes.
I tried to replace the LEXAR 16Gb U1 SD card with a SAMSUNG 32Gb EVO U1 and it all worked fine.
With the new SD the update has been successful at 0.11.4.
I tested the I2C MPU9150 HTU21 and BMP180 sensors without any problems.
In inspector I see the K signal I have configured.
Tonight I try to generate NMEA.
See you soon
I did not install a 'fresh Raspibian'.
I reinstalled OP 0.10 and retried the update to 0.11.4. Following the upgrade process carefully I saw an i / o error and a read only error reported, then the process abort and rpi3 reboot without upgrading.
In this abnormal condition the system freezes.
I tried to replace the LEXAR 16Gb U1 SD card with a SAMSUNG 32Gb EVO U1 and it all worked fine.
With the new SD the update has been successful at 0.11.4.
I tested the I2C MPU9150 HTU21 and BMP180 sensors without any problems.
In inspector I see the K signal I have configured.
Tonight I try to generate NMEA.
See you soon