This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › General discussion v
Best way to add multiple sensors?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Best way to add multiple sensors?
shark24 Offline
Member
***
Posts: 96
Threads: 0
Joined: Apr 2017
Reputation: 4
#2
2017-05-19, 10:17 AM (This post was last modified: 2017-05-19, 10:18 AM by shark24.)
Hi Steve,

I wouldn't want to measure the temp close to the RPi so I would go for multiple sensors and connect them via I2C. The I2C bus uses only two pins + VC and GND and it's very easy to use. There are tons of tutorials on youtube but if you need help with your setup this community will certainly help.

Best, Daniel
Find
Reply


Messages In This Thread
RE: Best way to add multiple sensors? - by shark24 - 2017-05-19, 10:17 AM
RE: Best way to add multiple sensors? - by PaddyB - 2017-05-19, 10:34 AM
RE: Best way to add multiple sensors? - by PaddyB - 2017-05-19, 12:35 PM
RE: Best way to add multiple sensors? - by PaddyB - 2017-05-19, 12:47 PM
RE: Best way to add multiple sensors? - by PaddyB - 2017-05-19, 01:48 PM
RE: Best way to add multiple sensors? - by PaddyB - 2017-05-19, 02:28 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)