2021-02-22, 06:44 PM
(This post was last modified: 2021-02-22, 06:50 PM by ALULAsails.)
Thanks Sailoog,
Quick question. My setup is already all soldered on Pin 4. I use 3 temp sensors as per your schematic and I have it all soldered exactly as per the schematic. (it was working perfect before my re-install of OpenPlotter)
This extra line you will add in next few days, will it solve the problem of app not opening for my case as well, or only for cases where one is wanting to use a different GPIO pin?
As always, thank you for your help. This whole OpenPlotter system is incredible.
UPDATE: I have added an extra empty line below
dtoverlay=w1-gpio
in my config file. I have rebooted.
This has not solved the issue, I cannot open the GPIO app unless I disconnect all 3 temp sensors.
Cheers
Quick question. My setup is already all soldered on Pin 4. I use 3 temp sensors as per your schematic and I have it all soldered exactly as per the schematic. (it was working perfect before my re-install of OpenPlotter)
This extra line you will add in next few days, will it solve the problem of app not opening for my case as well, or only for cases where one is wanting to use a different GPIO pin?
As always, thank you for your help. This whole OpenPlotter system is incredible.
UPDATE: I have added an extra empty line below
dtoverlay=w1-gpio
in my config file. I have rebooted.
This has not solved the issue, I cannot open the GPIO app unless I disconnect all 3 temp sensors.
Cheers