2021-02-23, 04:48 PM
Hi Guys and CapnKernel
I might be a bit naive but somewhere Sean said the motor controller can be connected directly to the TX and RX pins (or, via USB). Does this mean I can connect my motor controller (pololu jrk g2 21v3 and in picture) directly to RX/TX or do I still need to go via arduino nano as TinyPilot keeps saying no motor controller detected?
Many thanks
Richard
I might be a bit naive but somewhere Sean said the motor controller can be connected directly to the TX and RX pins (or, via USB). Does this mean I can connect my motor controller (pololu jrk g2 21v3 and in picture) directly to RX/TX or do I still need to go via arduino nano as TinyPilot keeps saying no motor controller detected?
Many thanks
Richard