Thanks for your response.
what IMU do you have? (Sorely missing some hardware guidance at this point)
The documentation has it using 3.3V, so that's what I am doing. I have also tried only hooking up SCL-SCA only, no cigar.
I2C enabled, not running has been there from the initial install- and yes I2C is enabled in the Pi settings. I can not really find any details on what this message means..
Seems either my Pi, or my MPU (or both?) are toast..?..
what IMU do you have? (Sorely missing some hardware guidance at this point)
The documentation has it using 3.3V, so that's what I am doing. I have also tried only hooking up SCL-SCA only, no cigar.
I2C enabled, not running has been there from the initial install- and yes I2C is enabled in the Pi settings. I can not really find any details on what this message means..
Seems either my Pi, or my MPU (or both?) are toast..?..