2021-10-29, 01:26 AM
(2021-10-29, 01:11 AM)Techstyle Wrote:No, how do I do that?(2021-10-29, 01:00 AM)Island_Moose Wrote:Did you check settings.json for:(2021-10-29, 12:40 AM)Techstyle Wrote:(2021-10-29, 12:09 AM)Island_Moose Wrote:(2021-10-28, 11:28 PM)Techstyle Wrote: I think that is the whole point of the mux - to multiplex all the signals to all the ports.
Do you see the GGA sentence coming in from the GPS device?
You should be able to add a TCP network connection in OpenCPN:
Protocol: TCP
Address: localhost
DataPort: 10110
check receive only
and then once added you will be able to pull up the NMEA debug window and see what sentences are available
I would use this instead of the SignalK connection you have (then you can use it to debug)
on the outgoing side, if you transmit only RMB, APB, XTE then you wont get loops
Protocol: UDP
Address: localhost
DataPort: 10110
Check Output only
in the Output filtering box "transmit sentences" RMB, APB, XTE
don't ignore any sentences in SignalK (you have RMB and APB ignored)
once you have done this show us the openCPN debug window
I'm getting good GPS sentences in OpenCPN, the plotter is working perfectly. I just can't find a way to send any data out of CPN (I want to send data to my autopilot and VHF).
there doesn't seem to be any positions in your GGA sentence
well you were screening out RMB and APB which have Autopilot sentences on them so you may want to not do that. As for the VHF what do you have selected in the SignalK to NMEA0183 plugin?
read this page: https://github.com/SignalK/signalk-to-nmea0183
I selected everything in the SignalK to nmea0183 plugin, and relevant GPS sentences in the nmea0183 to nmea0183 plugin.
Code:"toStdout": "nmea0183out"