2022-02-28, 07:50 PM
The hat.conf file changing was down to me running 'pypilot_hat none'. I thought this would not run the LCD pop-up (I an running pypilot on the same pi as Open CPN).
Many thanks for the lircrc config file and I have modified this to suit my LIRC set up.
If I now run ircat and press buttons on the remote, it all works OK:
pi@openplotter:/etc/lirc/lircrc $ ircat -c /etc/lirc/lircrc/lircrc.conf pypilot
1
2
3
4
5
6
7
8
9
But still nothing appearing on 33333. I think I may abandon IR and use an RF remote wired directly to the pi GPIO.
Many thanks
David
Many thanks for the lircrc config file and I have modified this to suit my LIRC set up.
If I now run ircat and press buttons on the remote, it all works OK:
pi@openplotter:/etc/lirc/lircrc $ ircat -c /etc/lirc/lircrc/lircrc.conf pypilot
1
2
3
4
5
6
7
8
9
But still nothing appearing on 33333. I think I may abandon IR and use an RF remote wired directly to the pi GPIO.
Many thanks
David