2022-04-11, 04:21 PM
(2022-04-11, 02:57 AM)seandepagnier Wrote:(2022-04-10, 07:33 AM)esm Wrote:(2022-04-10, 05:59 AM)seandepagnier Wrote: Which remote exactly? Is it the white rf remote or black ir remote?
It is the white 8 button remote
Ok. It is the RF remote. You mentioned the blue light shows which means the message is received by the microprocessor. Why it doesn't display in the web is a mystery.
Can you try debugging like this:
sudo systemctl pypilot_hat stop
cd pypilot/hat
python3 arduino.py
Now press buttons on the remote and see if any output messages are shown. Please post the output here, it can give clues to what is happening with your setup. Perhaps another process is trying to access the spi bus?
You may need to clone:
git clone github.com/pypilot/pypilot
Hi Sean, nothing is coming up after completing the above. Here is the output.
pi@openplotter:~ $ sudo systemctl pypilot_hat stop
Unknown operation pypilot_hat.
pi@openplotter:~ $ cd pypilot/hat
pi@openplotter:~/pypilot/hat $ python3 arduino.py
initializing arduino
hat firmware not in /home/pi/.pypilot/hat.hex
skipping verification
arduino on spidev0.1
nmea set baud [5]
baud rate TX: 0.0 RX 0.0
baud rate TX: 0.0 RX 0.0
baud rate TX: 0.0 RX 0.0
baud rate TX: 0.0 RX 0.0
baud rate TX: 0.0 RX 0.0
baud rate TX: 0.0 RX 0.0
baud rate TX: 0.0 RX 0.0
I will run the git clone now.