2022-10-01, 04:04 AM
(2022-09-30, 01:17 AM)seandepagnier Wrote: Can you confirm where the delay comes from? Is there an led or? 5 seconds is very long. If you manually use a switch (no pypilot not software) does it have a delay?
I didn't do additional testing yet of were this comes from. Only that the mosfet module works without delay if I connect this to a switch.
I'll try to connect the pypilot to a separate arduino nano. And just put a led (only a led) on the clutch pin an ground. To see if this also occurs when nothing else is connected.
Keep you posted..
Regards,
Wouter