This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › Pypilot › General discussion v
Using a hydraulic gear pump to have a clutch

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Using a hydraulic gear pump to have a clutch
seandepagnier Offline
Moderator
*****
Posts: 2,219
Threads: 20
Joined: Jun 2016
Reputation: 67
#5
2022-10-10, 09:12 PM
This seems right. It really depends on the boat. I have rigged my boat to do 2 seconds rather than the typical 6-8 but I am also sailing at speeds > 10 knots, but my rudder stalls beyond 20 degrees rather than 30, and I may have still overdone it.
Find
Reply


Messages In This Thread
RE: Using a hydraulic gear pump to have a clutch - by seandepagnier - 2022-10-10, 09:12 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)