2022-12-23, 12:23 AM
I have never seen anything other than a RED led light on the motor controller board (when its hooked upto 12v)
I'm assuming you don't need to have 12V hooked up unless wanting to test the actual motor drive, as the motor contoller board is hooked up to the 3.3V Supply on the RPI?
Swapping the serial UART RX/TX pins also so far hasn't made a difference.
I've even unplugged the USB/GPS and deleted it from the Serial 3.2.0 Console , so that if that's the source of the conflict, then I'll happily run without, but assumed some basic COG/SOG data would be needed by Pypilot?
When you say You may need to add /dev/ttyAMA0 to the list of serial ports pypilot can use, where should I do that, in Serial, Signal K, or a config file or a .PY etc?
Thanks
I'm assuming you don't need to have 12V hooked up unless wanting to test the actual motor drive, as the motor contoller board is hooked up to the 3.3V Supply on the RPI?
Swapping the serial UART RX/TX pins also so far hasn't made a difference.
I've even unplugged the USB/GPS and deleted it from the Serial 3.2.0 Console , so that if that's the source of the conflict, then I'll happily run without, but assumed some basic COG/SOG data would be needed by Pypilot?
When you say You may need to add /dev/ttyAMA0 to the list of serial ports pypilot can use, where should I do that, in Serial, Signal K, or a config file or a .PY etc?
Thanks