How to connect MPU9250

[yiannis]

Hi Yiannis,

did you try my tip setting AD0 to ground to set its Adress to 0x69 ?

For your Amazon Links, better look for an supported IMU from this List at https://github.com/seandepagnier/RTIMULib2/.
But you chip should work with this list and this list is used also in openplotter plugin.

Holger

Hi Holger,

I found a video [https://www.youtube.com/watch?v=mzwovYcozvI] for the specific MPU9250 board and it turns out that the AD0 needs to be connected to 5V rather than ground and then it will go to address 0x69.

So I did that, the address changed to 0x69 but PyPilot still cannot see it.

I will try to have a go with an Arduino (follow the instructions on the video) to see if it actually works and take it from there.

Regards,
Yiannis